Influence of Heat Treatment and the Coefficient of Friction on the Volume of Metal Removed During Grinding Steel 35

Authors

  • Igor Nikiforov Pskov state university
  • Pavel Maltsev Pskov state university

DOI:

https://doi.org/10.17770/etr2013vol2.861

Keywords:

abrasive grain, the front surface, depth of cut, heat treatment, microstructure, hardness, coefficient of friction

Abstract

The role of external friction and chip contraction during microcutting by abrasive grain is showed. The method for determining the relative change in the coefficient of friction during grinding is proposed. The hypothesis about the influence of physical and mechanical properties and microstructure of steel 35 on the volume removes metal through the change in the coefficient of sliding friction of the chip by face of the abrasive grain is experimentally proved.

Downloads

Download data is not yet available.

Author Biographies

  • Igor Nikiforov, Pskov state university

    Faculty of Mechanical and machine building, Departament of
    Technology of machinebuilding

  • Pavel Maltsev, Pskov state university
    Faculty of Mechanical and machine building, Departament of
    Technology of machinebuilding

References

Nikiforov I.P. Determination of volume of metal removed by a single abrasive grain for surface grinding. / I.P. Nikiforov, V.K Koshmak, N.F. Kudryavtseva // PPI Proceeding. – Series “Engineering”. Electric drive. – 2008. – №11.3. – pp. 218– 222.

Maltsev, P.N. Determination of the optimal granularity of the circle, providing maximum cutting power tool / P.N. Maltsev, I.P. Nikiforov // Physical basis of high-speed processing and technological support for computer technology in engineering. Materials of the international young researchers summer School. Ulyanovsk, 12–15 May of 2011th. – Ulyanovsk: Ulyanovsk STU, 2011. – pp. 168–172.

Goldstein, M.I. Metal Physics of high-strength alloys / V.S. Litvinov, B.M. Bronfin. – М. : Metallurgy, 1986. – 312 pp.

Livshits, L.S. Welding metal and heat treatment of welded joints / L.S. Livshits, A. Khakimov. - 2nd ed., Rev. and add. – М. : Engineering, 1989 – 336 pp.

Semenov, V.I. Influence of microstructure of the material in the adhesive component of friction / V.I. Semenov, L.Sh. Shuster, G.I. Raab // Friction, wear, lubrication [Electronic resource]. – 2008. – №28. – Access mode: http://www.tribo.ru/netcat_files/ 313/208/h_994233f617f64e4ea7bbab254fc0714e.

Kuznetsov, А.А. Determination of cutting forces acting on the cutting edge of the unit worn abrasive grain / А.А. Kuznetsov, V.V. Fedotov // Proceeding of IV Russian Conference-seminar «Science and Engineering: Problems and Prospects». Syzran 22 May 2009th – Samara: P.h. “Samara State University”, 2009.

Filimonov, L.N. High-speed grinding. – L.: Engineering, Leningrad Department, 1979. – 248 pp.

Downloads

Published

2015-08-08

How to Cite

[1]
I. Nikiforov and P. Maltsev, “Influence of Heat Treatment and the Coefficient of Friction on the Volume of Metal Removed During Grinding Steel 35”, ETR, vol. 2, pp. 72–78, Aug. 2015, doi: 10.17770/etr2013vol2.861.